【Ready Stock】Original Aideepen Automatic Temperature Control Incubator Tool Household Foam Bionic Incubator for All Kinds of Poultry Eggs Choose 20 Pieces/22 Pieces/42 Pieces/50 Pieces

Product selling points:
1. 100% brand new and high-quality products.
2. Made of high-quality materials, durable and practical.
3. The temperature difference of the machine can be calibrated according to the measured temperature, so that the temperature is more accurate and the shell rate is higher.
4. Double power supply, not afraid of power failure.
5. Bionic incubation, inspired by the structure and function of the organism, the bionic water bed designed according to the incubation conditions of the mother can easily hatch every egg.
6. Accurate temperature control, self-contained photo eggs, not afraid of power outages, low energy consumption

Parameter:
Product voltage: AC110V-220V/DC12V
Power: 20W
Size: 36*24*19cm
Plug: American plug
Scope of application: all kinds of poultry eggs

Instructions:
Step 1: First add proper amount of water to the hatching water bag, ready to use.
Step 2: After receiving the incubator, lay the bottom heating pad flat. Place a water bag filled with water on the heating pad. The opening of the water bag is fixed in the foam box next to the incubator with a clip to prevent water from splashing out.
The third step: Put the temperature sensor into the water bag and fix it with tape (it must be attached to the surface of the water bag and contact with the water bag). When you are ready, put the eggs.
Step 4: Start the test machine. After the temperature stabilizes, evenly put the sterilized eggs into the water bag in the incubator.
Step 5: In the incubator, after the hatched eggs are laid, cover the quilt on the egg with a breathable and warm quilt. It will not be too loose or too tight. The hatching process does not need to cover the lid of the incubator. If the temperature is low, the quilt should be tightly covered ; If the temperature is high, do not cover it too tightly.
Step 6: Fill the watering can with water, put it into the machine, and keep the water temperature in the kettle consistent with the temperature of the eggs. Spray water three days before hatching, 2-3 times a day.

Notice:
Be sure to test whether the water bag leaks, otherwise it will cause the risk of short circuit.
You must ensure that the material being covered is breathable and that there is enough oxygen in the incubator.
Turn the eggs in the incubator upside down every day (2-3 times/day). Don't turn the eggs to remove heat.