ELM327 USB Diagnostic Cable With Switch For Code Reader Focccus FF2 Elmconfig XDCN

[{"t":"Basic Features:\nReset fault /trouble codes / parameter ids (PIDs)\nChange car configuration data\nRun tests\nServices procedures\nProgram certain models\nPin Configurations:\nSwitch position one: HS CAN - Occupies pins 6 and 14\nSwitch position two: MS CAN - Occupies pins 3 and 11\nSupported Software:\nElmconfig\nFoCCCus\nFF2\nPlus more\nModified EML:\nPlease note that many Ford and Mazda models (approximately since 2003-2004) are equipped with MS CAN bus, in addition to the regular HS CAN bus. In contrast to HS CAN bus, MS CAN bus is not supported by the stock ELM327, because MS CAN\nis a manufacturer-specific solution and located on non-OBD2 pins. This ELM327 has been modified to allow it to implement the MS CAN bus.\nELM327 supports HS CAN from the stock, because For.d HS CAN completely matches to the OBD2 standards. It occupies pins 6 and 14. MS CAN bus occupies pins 3 and 11.\nSupported Vehicles:\nAll For.d, Mazda, Lincoln, Mercury vehicles that can be addressed using an ELM via an OBDII connector.\nSupported Protocols:\nFOR.D HS CAN\nFOR.D MS CAN\nColour: Black\nMaterial: plastic + metal\n\nPackage Contents:\n1 x ELM327 Diagnostic Interface\n1 x CD\nOther Details:\nCables fully tested on supported model before shipping.\nNo responsibility can be accepted for any damage caused by the lead.\nOnly the above package content, other products are not included.\nNote: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm."}]