1PCS DC 6V-30V 1 channel 5V Relay module Time delay relay module triggers OFF/ON switch timing period 999 minutes Arduino relay board

Rơ Le module, delay, off, trigger delay, circuit switching Cycle time 0.1 seconds (phút) to 999 minutes (tối đa) CanDeals continuously adjustable. Highlights: 1. Wide voltage power supply (6~30V), support MicroUSB 5.0V power supply, easy to use; 2. The interface is clear and concise, powerful, easy to understand, and can meet almost all your needs; 3. Emergency stop function ("Stop" button) ; With reverse polarity protection, reverse polarity will not burn the product. 4. Add sleep mode, if this mode is activated, if there is no operation in Time 5 minutes, the display will be automatically turned off, any main wake up; 5. tham số OP, CL, lop are different, independent of each other, and automatically saved; 6. All parameter settings are not lost after the module is turned on. Running mode: P1: badminton, badminton là badminton "OP", badminton Đan Mạch; "OP" flywheel, flywheel: P1.1: Trigger signal again, invalid P1.2: xích xích, xích xích, xích xíchP1.3: Trigger signal again, bạn Rơle, kêt stop;P-2: Trigger signal, rơle turns on “CL” time, rơle at “OP” time, rơle cut off And then; P3.1: Signal transmission, turn on after “OP” time, rơle turn on “CL” time, đột định then loop, IF cycle trigger signal, Rơle, mứt stop; number of cycles ("lop") can be set. P3.2: Signal is not triggered, rơle là is at "OP" time, rơle là "CL" time, and has been cycled; the cycle frequency ("lop") can be set; P-4: Signal hold function. If the Time trigger signal is cleared, the Relay will be kept; when the signal disappears, the time "OP" has elapsed, and the relay will be là; if there are other signals during the Time period, the Time will be cleared; Thông số: 1: Working voltage: 6-30V, Support MicroUSB 5.0V powerOnce, then return to the main screen, set the parameters successfully! Main interface: Display "000" (without decimal point) when Relay is not working, with decimal point in relay state Mode selection interface: Press and hold the "Settings" button to enter, after the setting is completed, long press the "Settings" button to return to the main screen. "Stop" button extension: Rơ Le Enable mode: 1. Bảt: Bộ được trần on time in "OP"; 2. สี่มี่: สี่วัววัว disables streaming all the time off; in the main interface, press the "berhence" button to toggle between on and off, and where it flashes, then return to the main screen. (This function is emergency stop function, one click) Sleep mode: 1. "C-L" sleep mode: no operation for five minutes, the digital display is automatically turned off, and the program runs normally; 2. Normal mode "o-d": digital display is always on; press and hold the "DỪNG LẠI" button for two seconds and then release it to switch between "C-L" and "o-d" states, the current state flashes at this time, and then returns to the main screen.