Features:
A practical tool for roadside tire replacement and maintenance.
Sturdy steel construction with 1.5/2 tons (3300 lbs) load capacity
Allows you to easily adjust the height of vehicle to replace tire.
Precision threaded shaft for strength and long service life.
Compact size, can be stored in car trunk to use when needed.
Specification:
Capacity: 1.5 ton
Product length: 360mm
Max width: 90mm
Height raneg: 100-335mm
Material: Steel
Color: Black
Instruction:
1. Before use, park the vehicle, pull on the handbrake, and place a hazard warning sign.
2. Block the wheel diagonally opposite the replacement tire, loosen the replaced nut, but do not unscrew it.
3. Take out the jack and use a crank or wrench to raise the jack to a suitable height.
4. Place the jack under the specified lifting part, turn the handle clockwise to make the jack saddle contact the lifting part, and check whether the contact is safe and reliable.
5. Then shake the handle to lift the vehicle to a suitable height, replace the tire, and tighten the nut.
Note:
1. Avoid overloading!
2. To ensure the normal use of the jack, please keep the jack thread clean and lubricated. Before each use, apply enough oil on the lead screw!
3. This product can only be supported and cannot be used as a fixed support. When supporting the vehicle, it is strictly forbidden to enter the bottom of the vehicle!
4. Immediately stop using when skew occurs during the erection process, and use it after adjusting the position.
